The VikingPro is a shell dry suit made with a blend of natural and synthetic rubbers specifically designed for flexibility and comfort in a wide range of uses and environments. Providing protection from outside contaminants, the seams are stitched together and also use vulcanized rubber seam tape. The Heavy Duty magnetic zipper creates another protective seal, and additional layers of anti-slip textured rubber are found in the areas of high wear; shoulders, zipper, and rear of trousers. The VikingPro comes with latex neck and wrist seals providing a very water tight suit. The heavy duty boots on this suit are an extension of the leg, with the out sole featuring a non-slip surface for grip. The inflator is a push protected valve, and is positioned centrally on the chest. The exhaust valve is Viking’s X2 with 2 mushroom valves for added security, and is positioned on the upper left arm.
Follow the link below to determine how you can expect the dry suit to fit before you order it. If you need more specific measurement information, you can refer to the chart below for size and their coordinating measurements. Please give us a call if you’d like to schedule a fitting appointment!
This VikingPro suit is covered in epoxy glue, although it may not be the prettiest dry suit out there, it’s still a functional heavy-duty dry suit with lots of life left in it. Our dry suit technician can trim both neck and wrist seals to fit. If necessary, we can also replace the latex seals for a smaller fit. Give us a call for an estimate.
*****Our on site gear specialist has air tested this suit and determined the suit to be leak free.*****
Internet Special: Ugly Suit Discount
25% OFF OUR ALREADY LOW STORE PRICE!